1. Water tank: storage of tap water, to solve the problem of insufficient tap water pressure and the back booster pump due to the impact of insufficient water, reduce the failure rate
2. Booster pump:equipped with a stainless steel pump, to provide sufficient pressure for subsequent filtration
3. Quartz sand filter: mainly remove the mud, suspended solids and large particles in the tap water
4. Carbon filter: mainly remove organic substances, residual chlorine and odor in tap water
5. Water softener filter: mainly remove the calcium and magnesium in tap water, reduce the hardness of water
6. Security filter: further filtration, protection of reverse osmosis membrane
7. High pressure pump: provide enough pressure for reverse osmosis system
8. Reverse osmosis unit: the core part of pure water equipment, the production of high-purity water.
9. Pure water tank: storage pure water, can change the size of the water tank,after the below process,The water result is pure enough for different application.
You can choose frp or stainsteel tank filter system and with or without pre-filter.We can customize the system according to your requirements.
Pretreatment including:
(1) Quartz sand/manganese sand filter (2) Activated Carbon filter (3) Softener and PP Filter (4) Dosing system if need.
Main Part of the machine:
(1)Pumps (2)RO membrane (DOW/CSM/Hydranautics) (3)Membrane Vessel(SS and FRP) (4)PLC control/Relay control (5)Optional UV sterlilizer&Ozone
Functions of Water Treatment:
(1)Auto flush (2)Low pressure protection (3)Membrane Vessel(SS and FRP) (4)High pressure protection (5)Back wash and Eneration control
Which model should I choose?
It depends on your raw water quality ,pure water requirement and the water production you need.
Direction for use
1. Place the host and preprocessor near the water source and power source. 2. Filter materials such as quartz sand, activated carbon and softening resin. 3. Connecting water: the water inlet of the original pump is connected with the water source, the outlet of the prefilter is connected with the host inlet, and the preprocessor and the host drain pipe are connected to the sewer by pipes. 4. Circuit: firstly, the grounding wire shall be grounded reliably, and the attached power line shall be connected to the room electric control box. 5. Access to the water source and power supply, according to the requirements of "pretreatment instructions", according to the steps, pre- processing and debugging are completed. 6. Use the machine, the original pump switch, dial in the automatic position,and rotate the stop switch.
7.Connect the water source and power supply, and when the pressure of the multi-stage pump reaches the set value of the pressure controller, the multi-stage pump starts work. 8.After the multi-stage pump is started, the system pressure is 0.7-1.0mpa. 9.For the first time, the RO membrane system is activated for 30 minutes manually.